|
| |
The TDR-10 Timed Power Relay serves to turn on a standard 120 Volt outlet
for a preset amount of time. This timed interval is initiated when a contact
is made across the Start terminals on the rear panel. This low voltage
contact may come from a pushbutton, motion sensor, or other device.
Once triggered, the timing cycle starts and the outlet switches on. While
timing, any additional start signals force the timing cycle to begin anew.
This ensures that there will be at least one complete cycle after the last
start signal. For example, if used with a motion sensor such as the Museum
Technology BB-200, the first visitor to approach will turn on the AC outlet
for the preset time. If no further motion is sensed, the outlet will switch
off at the end of the preset time. Should another visitor approach while the
outlet is on, the TDR-10 will start the timing cycle from the beginning. In
this way, as long a visitor motion is detected, the outlet will remain on,
shutting off only after motion has not been sensed for the preset time. |
 |
Technical Specifications: |
|
Timing Range |
05 seconds to 100 Hours |
|
Accuracy |
Within .05% |
|
Input Voltage |
120 Volts, 60 Hz |
|
Switching Capacity |
500
Watts |
|
AC Power Input |
Detachable IEC Cord supplied |
|
IAC Power Output: |
One standard NEMA-15 AC outlet |
|
Motion Sensor Power: |
24 Volts AC, 200 mA |
|
Start Input |
4 position 5.08 mm plug with screw terminals |
|
Warranty: |
Two years parts and labor |
|
Physical |
5.5” wide 5” deep 2.5” high, 2 lb |
|
Case |
Aluminum Extrusion and steel |
|
Warranty |
2 Years Parts and Labor
|
|
Country of Orgin |
United
States |
| |
|
|
Download Manual:
TDR-10 Instructions
Download
Cut Sheet:
TDR-10 Spec Sheet
Back to Products
|
